FibroLAN Falcon-RX/812/G/A User Manual page 130

Falcon R-Class | User Guide
Web GUI: Configuration > Security > Network > ACL > Access Control List
Figure 4-80: ACE Configuration displays
Table 4-76: ACL Configuration Parameters
ACE Configuration
Second Lookup Specify the second lookup operation of the ACE.
Ingress Port Select the ingress port for which this ACE applies.
•
•
Policy Filter Specify the policy number filter for this ACE.
•
•
Frame Type Select the frame type for this ACE. These frames are mutually exclusive:
•
•
•
•
•
130
All: The ACE applies to all port.
Port: The ACE applies to this port number, where n is the number of the
switch port.
Any: No policy filter is specified. (Policy filter status is "don't-care".)
Specific: If you want to filter a specific policy with this ACE, choose this
value. Two field for entering a policy value and bitmask appears.
Any: Any frame can match this ACE.
Ethernet Type: Only Ethernet Type frames can match this ACE. The IEEE
802.3 describes the value of Length/Type Field specifications to be
greater than or equal to 1536 decimal (equal to 0600 hexadecimal) and
the value should not be equal to 0x800(IPv4), 0x806(ARP) or
0x86DD(IPv6).
ARP: Only ARP frames can match this ACE. Notice the ARP frames will
not match the ACE with ethernet type.
IPv4: Only IPv4 frames can match this ACE. Notice the IPv4 frames will
not match the ACE with ethernet type.
IPv6: Only IPv6 frames can match this ACE. Notice the IPv6 frames will
not match the ACE with Ethernet type.