Msti Configuration - FibroLAN Falcon-RX/812/G/A User Manual

Falcon R-Class | User Guide
Bridge Priority
Hello Time
Forward Delay
Max Age
Maximum Hop
Count
Transmit Hold Count The number of BPDU's a bridge port can send per second. When exceeded,
Advanced Settings
Edge Port BDPU
Filtering
Edge Port BPDU
Guard
Port Error Recovery
Port Error Recovery
Timeout

MSTI Configuration

This section allows the user to inspect the current STP MSTI bridge instance (group of VLANs) priority
configurations, and possibly change them as well.
Add VLANs separated by spaces or comma.
187
Controls the bridge priority. Lower numeric values have better priority.
The bridge priority plus the MSTI instance number, concatenated with the
6-byte MAC address of the switch forms a Bridge Identifier.
For MSTP operation, this is the priority of the CIST. Otherwise, this is the
priority of the STP/RSTP bridge.
The interval between sending STP BPDU's. Valid values are in the range 1
to 10 seconds, default is 2 seconds.
Note: Changing this parameter from the default value is not
recommended and may have adverse effects on your network.
The delay used by STP Bridges to transition Root and Designated Ports to
Forwarding (used in STP compatible mode). Valid values are in the range
4 to 30 seconds.
The maximum age of the information transmitted by the Bridge when it is
the Root Bridge. Valid values are in the range 6 to 40 seconds,
Age must be <= (FwdDelay-1) *2.
This defines the initial value of remaining Hops for MSTI information
generated at the boundary of a MSTI region. It defines how many bridges
a root bridge can distribute its BPDU information to. Valid values are in
the range 6 to 40 hops.
transmission of the next BPDU will be delayed. Valid values are in the
range 1 to 10 BPDU's per second.
Controls whether a port, explicitly configured as Edge, will transmit and
receive BPDUs.
Control whether a port, explicitly configured as Edge, will disable itself
upon reception of a BPDU. The port will enter the
will be removed from the active topology.
Control whether a port in the
enabled after a certain time. If recovery is not enabled, ports must be
disabled and re-enabled for normal STP operation. This condition is also
cleared by a system reboot.
The time that must pass before a port in the
enabled. Valid values are between 30 and 86400 seconds (24 hours).
error-disabled
state automatically will be
error-disabled
error-disabled
Max
and
state and
state can be