Aggregation Group And Mode Configuration - FibroLAN Falcon-RX/812/G/A User Manual

Falcon R-Class | User Guide
TCP/UDP Port Number

Aggregation Group and Mode Configuration

R Class series allows set up of the Aggregation Mode Configuration and the Aggregation Group.
This section is used to configure the Aggregation hash mode and the aggregation group.
Web GUI: Configuration > Aggregation > Groups
Figure 4-154: Aggregation Group and Mode Configuration
Aggregation Group Configuration
Group ID
Port Members
Mode
212
The TCP/UDP port number can be used to calculate the
destination port for the frame.
Check to enable the use of the port number or uncheck to
disable.
By default, the port number is "Enabled".
Indicates the group ID for the settings contained in the same row.
Group ID "Normal" indicates there is no aggregation. Only one
group ID is valid per port.
Each switch port is listed for each group ID. Select a radio button
to include a port in an aggregation or clear the radio button to
remove the port from the aggregation. By default, no ports
belong to any aggregation group. Only full duplex ports can join
an aggregation and ports must be in the same speed in each
group.
This parameter determines the mode for the aggregation group.
•
Disabled: The group is disabled.
•
Static: The group operates in static aggregation mode.
•
LACP (Active): The group operates in LACP active aggregation
mode. See IEEE 801.AX-2014, section 6.4.1 for details.
•
LACP (Passive): The group operates in LACP passive
aggregation mode. See IEEE 801.AX-2014, section 6.4.1 for
details.