Qos Ingress Queue Policers - FibroLAN Falcon-RX/812/G/A User Manual

Falcon R-Class | User Guide

QoS Ingress Queue Policers

This section permits to configure the Queue Policer settings for all switch ports. A
the bandwidth of received frames. It is in front of the ingress queue
Web GUI: Configuration > QoS > Queue Policing
Figure 4-49: QoS Ingress Queue Policers display
Table 4-46: QoS Ingress Queue Policers Config parameters
Port The port number for which the configuration below applies.
Enable Enable or disable the queue policer for this switch port.
Rate Controls the rate for the queue policer. This value is restricted to
when Unit is kbps, and 1-
up to the nearest value supported by the queue policer.
Unit Controls the unit of measure for the queue policer rate as kbps, or Mbps
This field is only shown if at least one of the queue policers are enabled.
76
when Unit is Mbps. The rate is internally rounded
3276
Policer
.
-
100 3276700
can limit