FibroLAN Falcon-RX/812/G/A User Manual page 102

Falcon R-Class | User Guide
For example, tftp://10.10.10.10/new_image_path/new_image.dat,
http://username:password@10.10.10.10:80/new_image_path/new_image.dat. A
valid file name is a text string drawn from alphabet (A-Za-z), digits (0-9), dot (.),
hyphen (-), underscore (_). The maximum length is 63 and hyphen must not be first
character. The file name content that only contains '.' is not allowed.
Certificate Display the current status of certificate on the switch.
Status
Possible statuses are:
•
Switch secure HTTP certificate is presented.
•
Switch secure HTTP certificate is not presented.
•
Switch secure HTTP certificate is generating.
4.8.1.6 Access Management Configuration
In this subsection, you may configure the access management configuration.
The maximum number of entries is 16. If the application type matches any one of the access
management entries, it will allow access to the switch.
Web GUI: Configuration > Security > Switch > Access Management
Figure 4-69: Access Management Configuration display
Table 4-65: Access Management Configuration parameters
Mode
Delete
VLAN ID
Start IP address
End IP address
HTTP/HTTPS
SNMP
TELNET/ SSH
Buttons
102
Indicates the access management mode operation. Possible modes are:
•
Enabled: Enable access management mode operation.
•
Disabled: Disable access management mode operation.
Check to delete the entry. It will be deleted during the next save.
Indicates the VLAN ID for the access management entry.
Indicates the start IP address for the access management entry
Indicates the end IP address for the access management entry.
Indicates that the host can access the switch from HTTP/HTTPS interface
if the host IP address matches the IP address range provided in the entry.
Indicates that the host can access the switch from SNMP interface if the
host IP address matches the IP address range provided in the entry
Indicates that the host can access the switch from TELNET/SSH interface
if the host IP address matches the IP address range provided in the entry.
Add New Entry: Click to add a new access management entry.