FibroLAN Falcon-RX/812/G/A User Manual page 228

Falcon R-Class | User Guide
Web GUI: Monitor > LLDP > Neighbors
Figure 4-164: LLDP – Neighbor Information
Table 4-157: LLDP Neighbor Information Parameters
Local Interface
Chassis ID
Remote Port ID
Port Description
System Name
System Capabilities
Management Address
4.18.3.2 LLDP-MED Neighbour
This section provides a status overview of all LLDP-MED neighbours. The displayed table contains a
row for each port on which an LLDP neighbor is detected. This function applies to VoIP devices which
support LLDP-MED. The columns hold the following information:
Web GUI: Monitor > LLDP > LLDP-MED Neighbors
Figure 4-165: LLDP MED - Neighbour Information
228
The interface on which the LLDP frame was received.
The Chassis ID is the identification of the neighbor's LLDP frames.
The Remote Port ID is the identification of the neighbor port.
Port description is the port description advertised by the 228
neighbor unit.
System name is the name advertised by the neighbor unit.
Describes the 228 neighbor unit's capabilities. The possible
capabilities are:
•
Other
•
Repeater
•
Bridge
•
WLAN Access Point
•
Router
•
Telephone
•
DOCSIS cable device
•
Station only
•
Reserved
When a capability is "Enabled" – the capability is followed by (+).
When a capability is "Disabled" – the capability is followed by (-).
The neighbor unit's address used for higher layer entities to assist the
discovery by the network management. This could for instance hold
the neighbor's IP address.