FibroLAN Falcon-RX/812/G/A User Manual page 68

Falcon R-Class | User Guide
Interface Channel
Profile
Profile Management
Button
Port
Port Role
Buttons
68
membership. The value is in units of tenths of a second. The range is
from 0 to 31744. The default LLQI is 5 tenths or one-half second.
When the MVR VLAN is created, select the IPMC Profile as the channel
filtering condition for the specific MVR VLAN. Summary about the
Interface Channel Profiling (of the MVR VLAN) will be shown by clicking
the view button. Profile selected for designated interface channel is not
allowed to have overlapped permit group address.
You can inspect the rules of the designated profile by using the
following button: Navigate: List the rules associated with the
designated profile.
The logical port for the settings.
Configure an MVR port of the designated MVR VLAN as one of the
following roles.
•
Inactive: The designated port does not participate MVR operations.
•
Source: Configure uplink ports that receive and send multicast data
as source ports. Subscribers cannot be directly connected to source
ports.
•
Receiver: Configure a port as a receiver port if it is a subscriber port
and should only receive multicast data. It does not receive data
unless it becomes a member of the multicast group by issuing
IGMP/MLD messages.
•
Be Caution: MVR source ports are not recommended to be
overlapped with management VLAN ports. Select the port role by
clicking the Role symbol to switch the setting. I means Inactive; S
means Source; R means Receiver.
The default Role is Inactive.
Add New Click MVR VLAN: Click to add new MVR VLAN. Specify the VID
and configure the new entry. Click "Save".