FibroLAN Falcon-RX/812/G/A User Manual page 277

Falcon R-Class | User Guide
Destination Indicates the SNMP trap destination address. It allows a valid IP address in dotted
Address decimal notation ('x.y.z.w').
And it also allows a valid hostname. A valid hostname is a string drawn from the
alphabet (A-Za-z), digits (0-9), dot (.), dash (-). Spaces are not allowed, the first
character must be an alpha character, and the first and last characters must not
be a dot or a dash.
Indicates the SNMP trap destination IPv6 address. IPv6 address is in 128-bit
records represented as eight fields of up to four hexadecimal digits with a colon
separating each field (:). For example, 'fe80:: 215:c5ff:fe03:4dc7'. The symbol '::' is
a special syntax that can be used as a shorthand way of representing multiple 16-
bit groups of contiguous zeros; but it can appear only once. It can also represent a
legally valid IPv4 address. For example, ':: 192.1.2.34'.
Destination port Indicates the SNMP trap destination port SNMP Agent will send SNMP message via
this port; the port range is 1~65535.
Inform Mode Indicates the SNMP trap inform mode operation. Possible modes are:
•
•
Inform Timeout Indicates the SNMP trap inform timeout. The allowed range is 0 to 2147.
(seconds)
Inform Retry Indicates the SNMP trap inform retry times. The allowed range is 0 to 255.
Times
Security Engine Indicates the SNMP trap security engine ID. SNMPv3 sends traps and informs using
ID USM for authentication and privacy. A unique engine ID for these traps and
informs is needed. The string must contain an even number (in hexadecimal
format) with number of digits between 10 and 64, but all-zeros and all-'F's are not
allowed.
Security Name Indicates the SNMP trap security name. SNMPv3 traps and informs using USM for
authentication and privacy. A unique security name is needed when traps and
informs are enabled.
Trap Event
Configure SNMP trap on this page.
System Enable/disable that the Interface group's traps. Possible traps are:
•
•
Interface Indicates that the Interface group's traps. Possible traps are: Indicates that the
SNMP entity is permitted to generate authentication failure traps. Possible modes
are:
•
•
•
Authentication Indicates that the authentication group's traps. Possible traps are:
SNMP Authentication Fail: Enable/disable SNMP trap authentication failure trap.
277
Enabled: Enable SNMP trap inform mode operation.
Disabled: Disable SNMP trap inform mode operation.
Warm Start: Enable/disable Warm Start trap.
Cold Start: Enable/disable Cold Start trap.
Link Up: Enable/disable Link up trap.
Link Down: Enable/disable Link down trap.
LLDP: Enable/disable LLDP trap.