FibroLAN Falcon-RX/812/G/A User Manual page 46

Falcon R-Class | User Guide
Table 4-22: Global VLAN Configuration Parameters
Global VLAN Configuration
Allowed Access
VLANs
Ethertype for
Custom S ports
4.6.1.1 VLAN Port Configuration
The VLAN Port Configuration is used to configure per port VLAN related Parameters.
Web GUI: Configuration > VLANs > Configuration
46
This field shows the allowed Access VLANs, i.e., it only affects ports
configured as Access ports (the default port mode).
Ports in other modes are members of all VLANs specified in the Allowed
VLANs field (Ports in Trunk and Hybrid mode). By default, only VLAN 1 is
enabled. More VLANs may be created by using a list syntax where the
individual elements are separated by commas.
Ranges are specified with a dash separating the lower and upper bound.
The following example will create VLANs 1, 10, 11, 12, 13, 200, and 300:
1,10-13, 200, 300. Spaces are allowed in between the delimiters
This field specifies the ethertype/TPID (specified in hexadecimal) used for
Custom S-ports. The setting is in force for all ports whose Port Type is set to
S-Custom-Port.
S-Custom-Port:
On ingress, frames with a VLAN tag with a TPID = 0x8100 or equal to the
Ethertype configured for Custom-S ports get classified to the VLAN ID
embedded in the tag. If a frame is untagged or priority tagged, the frame is
classified to the Port VLAN. If frames must be tagged on egress, they will be
tagged with the custom S-tag.