Link Oam Mib Retrieval - FibroLAN Falcon-RX/812/G/A User Manual

Falcon R-Class | User Guide
64 bytes from fe80::219:5bff:fe2f:b47: icmp_seq=3, time=0ms
64 bytes from fe80::215:58ff:feed:69dd: icmp_seq=3, time=0ms
64 bytes from fe80::219:5bff:fe2f:b47: icmp_seq=4, time=0ms
64 bytes from fe80::215:58ff:feed:69dd: icmp_seq=4, time=0ms
Sent 5 packets, received 10 OK, 0 bad
You can configure the following properties of the issued ICMP packets
Table 6-2: ICMP PING Parameters
IP Address
Ping Length
Ping Count
Ping Interval
Egress Interface
(Only for IPv6)
Buttons

Link OAM MIB Retrieval

This procedure allows the user to retrieve the local or remote OAM MIB variable data on a particular
port.
Select the appropriate radio button and enter the port number of the switch to retrieve the
1
content of interest.
Click on Start to retrieve the content.
2
Click on New Retrieval to retrieve another content of interest.
3
298
The destination IP Address.
The payload size of the ICMP packet. Values range from 2 bytes to 1452
bytes.
The count of the ICMP packet. Values range from 1 time to 60 times.
The interval of the ICMP packet. Values range from 0 second to 30
seconds.
The VLAN ID (VID) of the specific egress IPv6 interface which ICMP
packet goes. The given VID ranges from 1 to 4094 and will be effective
only when the corresponding IPv6 interface is valid. When the egress
interface is not given, PING6 finds the best match interface for
destination.
Do not specify egress interface for loopback address.
Do specify egress interface for link-local or multicast address.
Start: Click to start transmitting ICMP packets.
New Ping: Click to re-start diagnostics with PING.