FibroLAN Falcon-RX/812/G/A User Manual page 55

Falcon R-Class | User Guide
4.6.3.2 VLAN Translation Mapping Table
This section allows you to create mappings of VLANs -> Translated VLANs and organize these
mappings into global Groups.
Web GUI: Configuration > VLAN Translation > VLAN Translation Mapping
Figure 4-31: VLAN Translation Mapping Table
Table 4-28: VLAN Translation Mapping Table parameters
Group ID The VLAN Translation mappings are organized into Groups, identified by the
Group ID.
This way a port is configured to use several VLAN Translation mappings easily
by simply configuring it to use a given group. Then number of possible groups
in a switch is equal to the number of ports present in this switch. A port can
be configured to use any of the groups, but only one at any given time.
Multiple ports can be configured to use the same group. A valid Group ID is
an integer value from 1 to 10.
Note: By default, each port is set to use the group with Group ID equal to
the port number. For example, port #1 is by default set to use group with
GID = 1.
Direction Indicates the direction of the VLAN Translation and it refers to the switch. The
direction can be 'Ingress', where the translation takes place on the VLAN ID of
frames entering the switch port, 'Egress', where the translation takes place on
the VLAN ID of frames exiting the switch port, or 'Both', where the translation
takes place on both above directions.
VID Indicates the ID to which Group ID will be mapped. A valid VLAN ID ranges
from 1-4095.
TVID Indicates the VLAN ID to which VLAN ID of an ingress frame will be translated
to (granted that the mapping is enabled on the ingress port that the frame
arrived at). A valid VLAN ID ranges from 1 to 4095.
Buttons Remove All: Click to remove all VLAN Translation mappings.
55