Port State - FibroLAN Falcon-RX/812/G/A User Manual

Falcon R-Class | User Guide
Description
Frame Length Check
RS-FEC / FEC Mode
Description
Buttons

Port State

This section provides an overview of the current switch port states (Each R Class series device has its
own Port State display).
Figure 4-15: Port State
The port states are illustrated as follows:
RJ45 ports
SFP ports
State Disabled
32
Indicates the description of the port. Maximum length of the Port
description String is 64. Port description can be null. When port
description is not null, it cannot contain space.
Configures if frames with incorrect frame length in the
EtherType/Length field shall be dropped. An Ethernet frame contains
a field EtherType which can be used to indicate the frame payload size
(in bytes) for values of 1535 and below. If the EtherType/Length field
is above 1535, it indicates that the field is used as an EtherType
(indicating which protocol is encapsulated in the payload of the frame).
If "frame length check" is enabled, frames with payload size less than
1536 bytes are dropped, if the EtherType/Length field doesn't match
the actual payload length. If "frame length check" is disabled, frames
are not dropped due to frame length mismatch. Note: No drop
counters count frames dropped due to frame length mismatch
Toggle Enable/Disable Reed-Solomon Forward Error Correction
User defined free text (up to 63 characters)
Apply -
Reset -
Refresh -
Port detailed -
Port Simplified Config -
Down Link