FibroLAN Falcon-RX/812/G/A User Manual page 170

Falcon R-Class | User Guide
VID VLAN Identifier used for tagging the VLAN packets.
PCP Priority Code Point value used for PTP frames.
DSCP DSCP value used when transmitting IPv4 encapsulated packets.
4.12.2.7 Master Enable on State
The Master Enable on State allow the user to control the PTP instance message transmission based
on the SyncCenter operational state. PTP transmission can be set to one of the following modes per
SyncCenter state:
•
Disabled – PTP transmission deactivated
•
Enabled - PTP transmission activated
•
Rule 0 - PTP transmission activation is conditioned to Instance 0 state
Figure 4-120: Master Enable on State
Table 4-114: Master Enable on State
Free Run In Free Run state PTP can be set to: Disable, Enable, Rule 0.
Lock Acquisition In Lock Acquisition state PTP can be set to: Disable, Enable, Rule 0.
Locked In Locked state PTP can be set to: Disable, Enable, Rule 0.
Holdover In Holdover state PTP can be set to: Disable, Enable, Rule 0.
Holdover In Holdover Recovery state PTP can be set to: Disable, Enable, Rule 0.
Recovery
4.12.2.8 Quality Override
Figure 4-121: Quality Override
Class Tick checkbox to enable Clock Class override, then set the desired value.
Accuracy Tick checkbox to enable Accuracy override, then set the desired value.
Variance Tick checkbox to enable Variance override, then set the desired value.
Table 4-115: Quality Override
4.12.2.9 Clock Default DataSet
Figure 4-122: Clock Type and Profile
170