Lldp Monitoring - FibroLAN Falcon-RX/812/G/A User Manual

Falcon R-Class | User Guide
Tagged indicates that the device is using the IEEE 802.1Q tagged frame format,
and that both the VLAN ID and the Layer 2 priority values are being used, as well
as the DSCP value. The tagged format includes an additional field, known as the
tag header. The tagged frame format also includes priority tagged frames as
defined by IEEE 802.1Q-2003.
VLAN ID VLAN identifier (VID) for the port as defined in IEEE 802.1Q-2003.
L2 Priority L2 Priority is the Layer 2 priority to be used for the specified application type. L2
Priority may specify one of eight priority levels (0 through 7), as defined by IEEE
802.1D-2004. A value of 0 represents use of the default priority as defined in IEEE
802.1D-2004.
DSCP DSCP value to be used to provide Diffserv node behavior for the specified
application type as defined in IETF RFC 2474. DSCP may contain one of 64 code
point values (0 through 63). A value of 0 represents use of the default DSCP value
as defined in RFC 2475.
Adding a new Click to Add New Policy. to add a new policy. Specify the Application type, Tag,
policy VLAN ID, L2 Priority and DSCP for the new policy. Click "Save".
The number of policies supported is 32.
Policies Interface Configuration
Every port may advertise a unique set of network policies or different attributes for the same
network policies, based on the authenticated user identity or port configuration.
Interface The interface number to which the configuration applies.
Policy Id The set of policies that shall apply to a given port. The set of policies is selected
by check marking the checkboxes that corresponds to the policies.
By clicking on "Add new policy" the following display is shown:
Web GUI: Configuration > LLDP > LLDP-MED | New Policy
Figure 4-163: LLDP-MED Configuration displays

LLDP Monitoring

LLDP Monitoring is implemented by collecting:
•
Neighbor
•
LLDP-MED Neighbor
•
EEE
•
Port Statistics
4.18.3.1 Neighbors
This page provides a status overview for all LLDP neighbors. The displayed table contains a row for
each interface on which an LLDP neighbor is detected. The columns hold the following information:
227