Qos Egress Port Shapers - FibroLAN Falcon-RX/812/G/A User Manual

Falcon R-Class | User Guide
Queue Scheduler Controls the weight for this queue. The default value is 17. This value is
Weight restricted to 1-100. This parameter is only shown if Scheduler Mode is set
to Weighted.
Queue Scheduler Shows the weight in percent for this queue. This parameter is only shown
Percent if Scheduler Mode is set to Weighted.
Port Shaper Enable Controls whether the port shaper is enabled for this switch port.
Port Shaper Rate Controls the rate for the port shaper. The default value is 500. This value is
restricted to
3300
Port Shaper Unit Controls the unit of measure for the port shaper rate as kbps or Mbps. The
default value is kbps.
Port Shaper Rate- The rate type of the port shaper. The allowed values are:
•
type
•

QoS Egress Port Shapers

This page provides an overview of QoS Egress Port Shapers for all switch ports.
This section provides an overview of QoS Egress Port Shapers for all switch ports.
Web GUI: Configuration > QoS > Port Shaping
Figure 4-52: QoS Egress Port Shapers display
Table 4-49: QoS Egress Port Shapers parameters
Port The logical port for the settings contained in the same row. Click on the port number
in order to configure the shapers.
Qn Shows "-" for disabled or actual queue shaper rate - e.g., "800 Mbps".
Port Shows "-" for disabled or actual port shaper rate - e.g., "800 Mbps".
79
-1000000 when the Unit is kbps, and it is restricted to 1-
100
when the Unit is Mbps.
Line: Specify that this shaper operates on line rate.
Data: Specify that this shaper operates on data rate.