FibroLAN Falcon-RX/812/G/A User Manual page 144

Falcon R-Class | User Guide
•
•
•
4.8.4.3 TACACS+ Sever Configuration
This page allows you to configure the TACACS+ servers.
TACACS+ is an acronym for Terminal Access Controller Access Control System Plus. It is a networking
protocol which provides access control for routers, network access servers and other networked
computing devices via one or more centralized servers. TACACS+ provides separate authentication,
authorization and accounting services.
Web GUI: Monitor > Security > AAA > TACACA+
Figure 4-91: TACACS+ Server Configuration
Table 4-87: TACACS+ Server Configuration Parameters
Global Configuration
Timeout
Deadtime
144
Not Ready: The server is enabled, but IP communication is not yet up
and running.
Ready: The server is enabled, IP communication is up and running, and
the RADIUS module is ready to accept access attempts.
Dead (X seconds left): Access attempts were made to this server, but it
did not reply within the configured timeout. The server has temporarily
been disabled but will get re-enabled when the dead-time expires. The
number of seconds left before this occurs is displayed in parentheses.
This state is only reachable when more than one server is enabled.
Timeout is the number of seconds, in the range
reply from a TACACS+ server before it is dead.
Deadtime, which can be set to a number between
the period during which the switch will not send new requests to a server
that has failed to respond to a previous request. This will stop the switch
from continually trying to contact a server that it has already determined
as dead.
Setting the Deadtime to a value greater than 0 (zero) will enable this
feature, but only if more than one server has been configured
to , to wait for a
1 1000
to minutes, is
0 1440