FibroLAN Falcon-RX/812/G/A User Manual page 149

Falcon R-Class | User Guide
Tx Timeouts
Other Info
Name RFC4670 Name
IP
-
Address
State -
Round-
radiusAccClientExtRoundTripTime
Trip Time
149
radiusAccClientExtTim
eouts
This section contains information about the state of the server and the
latest round-trip time.
Description
IP address and UDP port for the accounting server
in question.
Shows the state of the server. It takes one of the
following
Disabled: The selected server is disabled.
Not Ready: The server is enabled, but IP
communication is not yet up and running.
Ready: The server is enabled, IP communication is
up and running, and the RADIUS module is ready to
accept
Dead (X seconds left): Accounting attempts were
made to this server, but it did not reply within the
configured timeout. The server has temporarily
been disabled but will get re-enabled when the
dead-time expires. The number of seconds left
before this occurs is displayed in parentheses. This
state is only reachable when more than one server
is enabled.
The time interval (measured in milliseconds)
between the most recent Response and the
Request that matched it from the RADIUS
accounting server. The granularity of this
measurement is 100 ms. A value of 0 ms indicates
that there has not been round-trip communication
with the server yet.
Request is sent and decremented due to receipt
of a Response, timeout, or retransmission.
The number of accounting timeouts to the
server. After a timeout, the client may retry to
the same server, send to a different server, or
give up. A retry to the same server is counted as
a retransmit as well as a timeout. A send to a
different server is counted as a Request as well as
a timeout.
accounting
values:
attempts.