Network Security - FibroLAN Falcon-RX/812/G/A User Manual

Falcon R-Class | User Guide
4.8.1.7 Access Management Statistics
This sub-section provides statistics for selected access management.
Web GUI: Monitor > Security > Access Management Statistics
Figure 4-70: Access Management Statistics display
Table 4-66: Access Management Statistics Parameters
Interface
Received Packets
Allowed Packets
Discarded Packets

Network Security

Network Security includes the following subjects:
•
MAC Limit
•
Port Security switch and Port Security port status
•
Network Access Server (NAS)
•
Access Control List (ACL)
•
IP Source Guard ARP Inspection
4.8.2.1 MAC Limit Configuration
This section allows you to configure the MAC Limit Control system and port settings.
Limit Control allows for limiting the number of users on a given port. A user is identified by a MAC
address and VLAN ID. If Limit Control is enabled on a port, the limit specifies the maximum number
of users on the port. (This number cannot exceed 1024). If this number is exceeded, an action takes
place. The action can be one of the four different actions as described below. The Limit Control
module utilizes a lower-layer module, Port Security module, which manages MAC addresses learnt
on the port.
•
The Limit Control configuration consists of two sections:
•
System Configuration
•
Port Configuration
103
The interface type through which the remote host can access the switch.
Number of received packets from the interface when access
management mode is enabled.
Number of allowed packets from the interface when access management
mode is enabled.
Number of discarded packets from the interface when access
management mode is enabled.