FibroLAN Falcon-RX/812/G/A User Manual page 24

Falcon R-Class | User Guide
4.3.5.1 NTP Client Configuration
The NTP client configuration allows the switch to set the IP address of up to 5 different NTP servers
as a time source. Additionally, server polling interval and encryption options can be configured.
Maximum and minimum polling values in seconds are between 8-131072(approximately 36.4 hours).
Web GUI: Configuration > Timing > NTP
Figure 4-7: NTP Client Configuration
Table 4-5: NTP Client Configuration Parameters
Client Configuration
Mode
Server ID
Server IP
Min Poll
Max Poll
MD5 Key
Key ID
24
Indicates the NTP Client operation mode. Possible modes are:
Enabled: Enable NTP mode operation.
Disabled: Disable NTP mode operation.
Up to 5 different servers can be configured
Provide the IPv4 or Ipv6 address of a NTP server..
Value in seconds. Available selected options are 2
Value in seconds. Available selected options are 2
Enable per server MD5 encryption for NTP session authentication
Set per server MD5 encryption key value for NTP session
3 4 5 17
, 2 , 2 ... 2
3 4 5 17
, 2 , 2 ... 2