Ports Configuration And Monitoring - FibroLAN Falcon-RX/812/G/A User Manual

Falcon R-Class | User Guide

4.4 Ports Configuration and Monitoring

This section shows current port configurations. Ports may be configured here.
Ports are also monitored here.
Web GUI: Configuration > System > Ports
Figure 4-14: Port Configuration
Table 4-12: Port Configuration Parameters
Port
Link
Current Speed
Configured
Speed
30
This is the logical port number for this row.
The current link state is displayed graphically.
•
"Green" indicates that the link is up.
•
"Red" indicates that the link is down.
•
"Grey" Indicates that the port is inactive
Provides the current link speed of the port.
Selects available link speed for the given switch port. Only speeds
supported by the specific port are shown. Possible speeds are:
•
Disabled - Disables the switch port operation.
•
Auto - Port auto negotiating speed and duplex with the link
partner and selects the highest speed that is compatible with the
link partner.
•
10Mbps HDX - Forces Cu port in 10Mbps half-duplex mode.
•
10Mbps FDX - Forces Cu port in 10Mbps full duplex mode.
•
100Mbps HDX - Forces Cu port in 100Mbps half-duplex mode.
•
100Mbps FDX
- Forces Cu port in 100Mbps full duplex mode.
•
1Gbps FDX - Forces port in 1Gbps full duplex mode.
•
2.5Gbps FDX - Forces port in 2.5Gbps full duplex mode.
•
10Gbps FDX - Forces port in 10Gbps full duplex mode.
•
25Gbps FDX - Forces port in 25Gbps full duplex mode.