Igmp Sfm Information - FibroLAN Falcon-RX/812/G/A User Manual

Falcon R-Class | User Guide
Table 4-139: IGMP Snooping Groups Parameters
VLAN ID
Groups
Port Members

IGMP SFM Information

Entries in the IGMP SFM Information Table are shown on this section. The IGMP SFM (Source-Filtered
Multicast) Information Table also contains the SSM (Source-Specific Multicast) information. This
table is sorted first by VLAN ID, then by group, and then by Port. Different source addresses belonging
to the same group are treated as single entry.
Navigating the IGMP SFM Information Table
Each page shows up to 99 entries from the IGMP SFM Information table, default being 20, selected
through the "entries per page" input field. When first visited, the web page will show the first 20
entries from the beginning of the IGMP SFM Information Table. The "Start from VLAN", and "group"
input fields allow the user to select the starting point in the IGMP SFM Information Table. Clicking
Refresh the button will update the displayed table starting from that or the closest next IGMP SFM
Information Table match. In addition, the two input fields will - upon a button click - assume the
value of the first displayed entry, allowing for continuous refresh with the same start address.
The >> will use the last entry of the currently displayed table as a basis for the next lookup. When
the end is reached the text "No more entries" is shown in the displayed table. Use the << button to
start over.
Web GUI: Configuration > IPMC > IGMP Snooping > IPv4 SFM Information
Figure 4-146: IGMP SFM Information
Table 4-140: IGMP SFM Information Parameters
VLAN ID
Group
Port
Mode
Source Address
Type
203
VLAN ID of the group.
Group address of the group displayed.
Ports under this group.
VLAN ID of the group.
Group address of the group displayed.
Switch port number.
Indicates the filtering mode maintained per (VLAN ID, port number, Group
Address) basis. It can be either Include or Exclude.
IP Address of the source. Currently, system limits the total number of IPv4
source addresses for filtering (per group) is 8. When there is no any source
filtering address, the text "None" is shown in the Source Address field.
Indicates the Type. It can be either Allow or Deny.