FibroLAN Falcon-RX/812/G/A User Manual page 54

Falcon R-Class | User Guide
Web GUI: Configuration > VLAN Translation > Port to Group Configuration
Figure 4-30: VLAN Translation Port Configuration
Table 4-27: Port to Group mapping Table Parameters
Port The Port column shows the list of ports for which you can configure the VLAN
Translation Mapping Group.
Default To set the switch port to use the default VLAN Translation Group click the checkbox
and press Save.
Group ID The VLAN Translation mappings are organized into Groups, identified by the Group
ID. This way a port is configured to use several VLAN Translation mappings easily
by simply configuring it to use a given group. Then the number of possible groups
in a switch is equal to the number of ports present in this switch. A port can be
configured to use any of the groups, but only one at any given time. Multiple ports
can be configured to use the same group. A valid Group ID is an integer value from
1 to 21.
Note: By default, each port is set to use the group with Group ID equal to the
port number. For example, port #1 is by default set to use group with GID = 1.
For example, port #1 is by default set to use group with GID = 1.
54