Toshiba e-STUDIO2008A Service Manual page 551

Multifunctional digital systems
Hide thumbs Also See for e-STUDIO2008A:
Table of Contents

Advertisement

Error code
Classification
EA32
Finisher jam
(Finisher section)
EA40
EA50
EA60
EA70
EA80
Finisher jam
(Saddle Stitcher
section)
EA81
EA90
EAA0
EAB0
EAB1
EAC1
EAD0
Other jam
© 2015 TOSHIBA TEC CORPORATION All rights reserved
Contents
Exit paper remaining jam. [MJ-1101/1107/MJ-1106/
1108]
Exit paper remaining jam in the Finisher: Paper is
detected in the finishing tray sensor when the
power is turned ON. [MJ-1032/MJ-1033]
Cover open error:
The front cover or stationary tray cover is opened
during paper transport. [MJ-1101/1107/MJ-1106/
1108]
Finisher cover open jam:
(1) A paper jam occurs when any of the covers is
opened during the transporting of paper in the
Finisher (until the paper exit is completed after the
B command has been received).
(2) A paper jam occurs when the supplying of the
voltage of 24V is stopped during the transporting of
paper. [MJ-1032/MJ-1033]
Stapling jam: Stapling is not performed properly.
[MJ-1032/MJ-1033]
Early arrival jam: A paper jam occurs because
paper from the equipment arrives at the Finisher
too early. [MJ-1032/MJ-1033]
Stack exit belt home position error: The stack exit
belt is not at the home position. [MJ-1101/1107/MJ-
1106/1108]
Stapling jam: Stapling is not performed properly.
[MJ-1032/MJ-1033]
The detection of the home position of the saddle
stitch 3rd transport roller drive motor ends
abnormally.
Door open jam: The delivery cover or inlet cover
has opened during printing. [MJ-1106/1108]
Paper remaining in Saddle Stitch Finisher: Paper
remaining in Saddle Stitch Finisher [MJ-1106/1108]
Paper transport jam in Saddle Stitch Finisher:
Paper transport jam in Saddle Stitch Finisher
[MJ-1106/1108]
Short paper jam: Short paper jam (Saddle Stitch
Finisher) [MJ-1106/1108]
The detection of the home position of the folding
blade motor ends abnormally.
Print end command time-out jam: The printing has
not finished normally because of the
communication error between the SYS board and
LGC board at the end of printing.
8 - 13
Troubleshooting
P. 8-127
P. 8-128
P. 8-128
P. 8-129
P. 8-129
P. 8-130
P. 8-131
P. 8-132
P. 8-132
P. 8-133
P. 8-133
P. 8-135
P. 8-104
e-STUDIO2008A/2508A/3008A/3508A/4508A/5008A
ERROR CODE AND TROUBLESHOOTING
8
-
-

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents