Toshiba e-STUDIO2008A Service Manual page 991

[B] Restore procedure
(1) Shut down the equipment.
(2) Connect the USB device [1] to the USB port [2] on the right upper cover.
(3) Press the HS-59 - [Restore SRAM Data from USB].
(4) Enter the password (max. 15 characters) which has been set in (8) of "[A] Backup procedure".
(5) Enter the serial number for the backup file.
(6) "Restore successfully done Restart the MFP" is displayed on the LCD screen when the restoring
has been properly completed.
(7) Shut down the equipment.
Notes:
• When the back-up file is restored, do not perform HDD partition creation (Format HDD) before
the normal start-up.
• To perform cloning with the SRAM data backed up before the ADI-HDD is initialized or
replaced, follow the procedure below after the restoration is finished.
1. Perform [HS-73] and press [Key Backup/Restore].
2. Press the [ADIKey] and then [Execute].
3. Wait until the restoring of the encryption key is completed. "Success" is displayed.
4. Then turn the power OFF.
© 2015 TOSHIBA TEC CORPORATION All rights reserved
[2]
[1]
Fig.12-2
12 - 3
e-STUDIO2008A/2508A/3008A/3508A/4508A/5008A
BACKUP FUNCTION
12