Toshiba e-STUDIO2008A Service Manual page 792

[ 3 ] Electronic Filing related error
[2B10] No applicable job error in Job control module
[2B11] JOB status abnormality
[2B20] File library function error
[2B30] Insufficient disk space in BOX partition
[2BC0] Fatal failure occurred
[2BC1] System management module resource acquiring failure
Classification
Electronic Filing related error
Check item
Setting
Replace parts
SYS board
[2B21] Exceeding file capacity
Classification
Electronic Filing related error
Check item
Setting
[2B31] Status of specified Electronic Filing or folder is undefined or being created/deleted
Classification
Electronic Filing related error
Check item
Setting
[2B32] Electronic Filing printing failure: Specified document can not be printed because of
client's access (being edited, etc.)
Classification
Electronic Filing related error
Check item
Setting
e-STUDIO2008A/2508A/3008A/3508A/4508A/5008A
ERROR CODE AND TROUBLESHOOTING
トラブルシューティングの内容がEX-Loire2のため、別途修正します。
• Erase some data in the Electronic Filing or the shared
folder and perform the job in error again (in case of
[2B30]).
• Turn the power OFF and then back ON. Perform the job in
error again.
• Check that there is no other job in progress, and format
the HDD with [5] + [C] + [START].
• If the recovery is still not completed, replace the SYS
board.
• Reset and extend the "Maximum send to E-mail/Internet
FAX size" or reduce the number of pages and perform the
job again.
• Check if the specified Electronic Filing or folder exists. (If
no, this error would not occur.)
• Delete the specified Electronic Filing or folder.
• Perform the job in error again.
• If the specified box/folder cannot be deleted, initialize the
Electronic Filing with [5] + [C] + [START].
• Check if the specified document exists. (If no, this error
would not occur.)
Delete the specified document.
Perform the job in error again.
© 2015 TOSHIBA TEC CORPORATION All rights reserved
8 - 254
Error item
Measures
Remarks
Error item
Measures
Error item
Measures
Error item
Measures