Toshiba e-STUDIO2008A Service Manual page 349

• (05) adjustment value/(08) setting value difference
05 DIFFERENCE LIST
xx-xx-xx xx:xx
CODE
* 2400
The value differences between the factory default and the current value of [05 Adjustment mode]
and [08 Setting mode] in the FS Menu can be printed or output with a CSV file.
The mark "*" or "+" will be added to the left side of the code in the following cases.
"*": If there is a difference
"+": If there is no backed up value
Notes:
• Back-up data of the factory default are automatically created when the automatic gamma
adjustment of the easy set-up mode has been completed during the unpacking and setting up of
the equipment. The back-up file will be retained even if the system firmware is upgraded.
However, the file will be deleted when the HDD is formatted or replaced.
• When the easy set-up mode is restarted while a specified value such as 4 through 8 is set for
FS-08-9022 (Production process management status for easy setup), the back-up file stored
during unpacking and setting-up is deleted after the completion of the automatic gamma
adjustment and a new one is created while the value as of then is stored.
• When no back-up file exists
When 30-121 (122) is performed, the equipment returns to the ready state of the 30 LIST PRINT
MODE without performing printing.
When 30-221 (222) is performed, the equipment returns to the ready state of the 30 LIST PRINT
MODE and the error message "The file cannot be saved." appears on the panel.
© 2015 TOSHIBA TEC CORPORATION All rights reserved
BACKUP CURRENT
128 160
Fig.5-19
5 - 31
S/N: xxxxxxxxx TOTAL:
DF TOTAL:
TOSHIBA e-STUDIOxxxx
CODE
BACKUP CURRENT
e-STUDIO2008A/2508A/3008A/3508A/4508A/5008A
9999999
9999999
SELF-DIAGNOSTIC MODE
5