Toshiba e-STUDIO2008A Service Manual page 869

8.4.11 Skew (inclined image)
Defective area
Drawers
LCF
Feed roller
Rollers
Registration roller
Pre-registration guide
Scanner
© 2015 TOSHIBA TEC CORPORATION All rights reserved
Fig.8-14
Step Check items
1 Is the drawer or LCF properly
installed?
2 Is there too much paper in the drawer
or LCF?
3 Is the corner of the paper folded?
4 Are the side guides of the drawer or
LCF properly installed?
5 Is the surface of the feed roller dirty?
6 Are the roller and shaft secured?
7 Is the spring detached from the
registration roller?
8 Is the pre-registration guide properly
installed?
9 Is the carriage-1 slanted?
8 - 331
Prescription
Install the drawer or LCF properly.
Reduce paper to 550 or fewer sheets
in the drawer. Reduce paper to 1000
or fewer sheets in the feeding side
tray and the standby side tray of LCF,
respectively.
Change the direction of the paper
and set it again.
Adjust the position of the side guides.
Clean the feed roller surface with
alcohol, or replace the roller.
Check and tighten the E-rings, pins,
clips and setscrews.
Attach the spring correctly. Clean the
roller if it is dirty.
Correct it.
Adjust the carriage-1.
e-STUDIO2008A/2508A/3008A/3508A/4508A/5008A
ERROR CODE AND TROUBLESHOOTING
8