Toshiba e-STUDIO2008A Service Manual page 194

Notes:
When installing, fix it using the sensor holder
projection [2] and latch [3].
(6) Disconnect 2 connectors. Remove the 2nd
drawer empty sensor [4] and the 2nd drawer
tray-up sensor [5].
Notes:
When installing connectors, connect the
white connector to the 2nd drawer empty
sensor [4], and the yellow connector to the
2nd drawer tray-up sensor [5].
4.5.30 1st drawer paper width detection switch (SW6) and 1st drawer
paper length detection switch (SW7)
(1) Remove the rear cover.
 P. 4-6 "4.1.15 Rear cover"
(2) Remove 1 spring [1] and disconnect the 2
connectors [2].
Notes:
When installing, connect the yellow harness
connector to the left side.
(3) Release the latch, and remove the switch
holder [3].
e-STUDIO2008A/2508A/3008A/3508A/4508A/5008A
DISASSEMBLY AND REPLACEMENT
© 2015 TOSHIBA TEC CORPORATION All rights reserved
4 - 74
Fig. 4-202
Fig. 4-203
Fig. 4-204