Toshiba e-STUDIO2008A Service Manual page 136

4.2.5 DSP board
(1) Remove the control panel unit.
 P. 4-8 "4.2.1 Control panel unit"
(2) Remove the hinge cover.
 P. 4-10 "4.2.2 Hinge cover"
(3) Remove the USB harness/signal harness.
 P. 4-11 "4.2.3 USB harness/signal
harness"
(4) Remove 4 screws and take off the bracket
[1].
(5) Remove the leaf spring [2]. Disconnect 1
connector and remove the flat cables [3], [4],
and [5], and then remove the DSP board [6].
Notes:
• When removing the flat cable [3], release
4 latches and remove it.
e-STUDIO2008A/2508A/3008A/3508A/4508A/5008A
DISASSEMBLY AND REPLACEMENT
© 2015 TOSHIBA TEC CORPORATION All rights reserved
4 - 16
Fig. 4-42
Fig. 4-43
Fig. 4-44