Toshiba e-STUDIO2008A Service Manual page 225

4.8.3 Filling developer unit with developer material
(1) Install the developer nozzle jig on the
developer bottle.
(2) Rotate the gear on the rear side of the
developer unit to the direction of the arrow
while filling the developer unit with the
developer material. Spread out the developer
material over the developer sleeve.
4.8.4 EPU memory board (EPU)
(1) Remove the developer material.
( P. 4-104 "4.8.2 Removing developer
material")
(2) Place the developer unit upside down.
Disconnect 2 connectors.
(3) Remove 1 screw. Then take off the EPU
memory board.
© 2015 TOSHIBA TEC CORPORATION All rights reserved
Lid
Fig. 4-283
EPU memory board
Fig. 4-284
Fig. 4-285
e-STUDIO2008A/2508A/3008A/3508A/4508A/5008A
4 - 105
EPU memory board
DISASSEMBLY AND REPLACEMENT
4