Toshiba e-STUDIO2008A Service Manual page 288

(7) Remove 1 screw and take off the cover.
(8) Remove 1 screw and take off the ground
cable. Disconnect 2 connectors.
[1] Damp heater harness (JPD)
[2] Signal harness
(9) Remove 6 screws and take off the rear
cover.
(10) Remove 2 screws and take off the SYS
board cover.
e-STUDIO2008A/2508A/3008A/3508A/4508A/5008A
DISASSEMBLY AND REPLACEMENT
© 2015 TOSHIBA TEC CORPORATION All rights reserved
4 - 168
Fig. 4-450
[1]
[2]
Fig. 4-451
Fig. 4-452
Fig. 4-453