Toshiba e-STUDIO2008A Service Manual page 139

4.3.3 Automatic original detection sensor-1, -2 (S1, S2)
(1) Remove the lens cover.
 P. 4-18 "4.3.2 Lens cover"
(2) Remove 1 screw and disconnect 1 connector
[1], and then take off the automatic original
detection sensor-1 and -2 [2].
Notes:
A4 models are equipped only with automatic
original detection sensor-1 and LT models
are equipped with automatic original
detection sensors-1 and -2.
4.3.4 Lens unit/CCD driving PC board
(1) Remove the lens cover.
 P. 4-18 "4.3.2 Lens cover"
(2) Remove 1 screw and take off the automatic
original detection sensor with the bracket [1].
(3) Release the lock by tilting the flap and
remove 1 flat cable [2].
© 2015 TOSHIBA TEC CORPORATION All rights reserved
Fig. 4-49
Fig. 4-50
Fig. 4-51
e-STUDIO2008A/2508A/3008A/3508A/4508A/5008A
4 - 19
DISASSEMBLY AND REPLACEMENT
4