6.12.3
Adjustment of skew
Notes:
Check if the image adjustment for the equipment is performed properly before this adjustment of
the RADF. Also, the RADF position and height shall be adjusted properly.
[A] Checking
Check the image using the chart (original) with vertical and horizontal lines in the following procedure.
Simplex copying:
(1)
Place the chart provided as an original with its face up on the original tray of the RADF, select [1
Sided 1 Sided] and press the [START] button.
(2)
Superimpose the chart on the copy and check the inclination of the copy image.
Duplex copying:
(1)
Place the chart provided as an original with its face down on the original tray of the RADF, select
[2 Sided 2 Sided] and press the [START] button.
(2)
Superimpose the chart on the copy and check the inclination of the copy image.
e-STUDIO2008A/2508A/3008A/3508A/4508A/5008A
SETTING / ADJUSTMENT
Fig.6-64 Chart (Original)
© 2015 TOSHIBA TEC CORPORATION All rights reserved
6 - 64