Toshiba e-STUDIO2008A Service Manual page 101

[ 2 ] Recovered process unit mechanism
The process unit of this equipment has two types; one is for the 20ppm/25ppm/30ppm and another is
for the 35ppm/45ppm/50ppm.
The differences between two are shown below.
Be sure not to install the process unit to a wrong model when replacing them because they are
incompatible each other.
To distinguish them, check the position of the bracket hole seen from the back side.
Parts
Toner recovery roller
Gear, belt
Discharge LED
Needle electrode
Position of bracket hole
(seen from the back side)
20ppm/25ppm/30ppm
© 2015 TOSHIBA TEC CORPORATION All rights reserved
20ppm/25ppm/30ppm
Not installed
For low speed
10 LEDs
For low speed
Bottom
Discharge LED
Needle
electrode
Toner recovery roller
Fig. 3-34
3 - 55
35ppm/45ppm/50ppm
Installed
For high speed
14 LEDs
For high speed
Top
35ppm/45ppm/50ppm
Gear, Belt
e-STUDIO2008A/2508A/3008A/3508A/4508A/5008A
OUTLINE OF THE MACHINE
3