Toshiba e-STUDIO2008A Service Manual page 297

4.13.4 KD-1059 (Large Capacity Feeder)
(1) Press the [Power] button on the control panel
to shut it down.
(2) Turn the main power switch of the equipment
off.
(3) Disconnect the power cable.
(4) Remove 1 screw and take off the cover.
(5) Disconnect 2 connectors. Remove 1 screw
and take off the ground cable.
[1] Damp heater harness (JPD)
[2] Signal harness
(6) Remove 3 screws and take off 2 fixing
brackets on the rear side.
© 2015 TOSHIBA TEC CORPORATION All rights reserved
Fig. 4-480
Fig. 4-481
Fig. 4-482
e-STUDIO2008A/2508A/3008A/3508A/4508A/5008A
4 - 177
[1]
[2]
DISASSEMBLY AND REPLACEMENT
4