Toshiba e-STUDIO2008A Service Manual page 330

5.6 [05 ADJUSTMENT MODE]
Various adjustments and test printing can be performed.
5.6.1 Adjustment
<Operation procedure>
• [05] indicates that the equipment is shifted to the [CLASSIC] mode after [05 ADJUSTMENT MODE]
is selected.
• The procedure indicated by the dotted lines should be performed when a check using a printout is
required.
Procedure 1
[Digital key]
[FS] [05]
(Code)
* Press [FUNCTION CLAER] to enter minus (-).
Procedure 2
[FS]
[05] [Digital key]
(Code)
Procedure 3
[Digital key]
[FS]
[05]
(Code)
Procedure 4
[FS]
[05] [Digital key]
(Code)
* Press [FUNCTION CLAER] to enter minus (-).
e-STUDIO2008A/2508A/3008A/3508A/4508A/5008A
SELF-DIAGNOSTIC MODE
[Digital key]
*[FUNCTION CLEAR]
[START]
(Key in a value)
[CANCEL]
(
Value
[START]
displayed
[UP]
or
[START]
[DOWN]
(Adjust a value)
[CANCEL]
[FUNCTION CLEAR]
(Corrects value)
[CANCEL]
[START]
[START] [Digital key] [START]
(Sub code)
[CLEAR]
(Corrects value)
[OK]
[ Test copy ]
[ START ]
[CLEAR]
(Stores value in RAM)
(Corrects value)
)
[OK]
(Value unchangeable)
[OK]
(Stores value in RAM)
[OK]
[Digital key]
Stores value
*[FUNCTION CLEAR]
in RAM
(Key in a value)
[CLEAR]
(Corrects value)
© 2015 TOSHIBA TEC CORPORATION All rights reserved
5 - 12
[POWER]
OFF/ON
(Exit)
[POWER]
OFF/ON
(Exit)
[Test copy]
[START]
[POWER]
OFF/ON
(Exit)
[ Test copy ]
[ START ]
[POWER]
OFF/ON
(Exit)
[Test copy]
[START]