Toshiba e-STUDIO2008A Service Manual page 444

(4) Position the pins with the holes on the RADF
by moving it so that the pins fit into the holes
when the RADF is closed.
(5) Tighten the left-hand hinge screw at the rear
side.
(6) Loosen the hole position adjustment screws
on the right hand side. (MR-3021/3022)
(7) Match the screw hole positions.
e-STUDIO2008A/2508A/3008A/3508A/4508A/5008A
SETTING / ADJUSTMENT
MR-3028
© 2015 TOSHIBA TEC CORPORATION All rights reserved
6 - 60
Fig.6-54
Fig.6-55
Fig.6-56
Fig.6-57