Notes:
•
When removing the flat cable [2], change
the lever position so that the connector is
released, and remove the flat cable by
lifting it up slightly (approx. 7 degrees) as
shown in the right figure.
•
When connecting the flat cable [2] to the
connector, insert the flat cable straightly
and lock it securely. Confirm that the tabs
are in the positions shown in the right
figure.
Notes:
•
When installing the flat cable [2], do not
push it in strongly.
•
When installing the flat cable [2], be
careful not to insert it at an angle.
•
Do not apply pressure to or damage the
edge of the flat cable [2].
e-STUDIO2008A/2508A/3008A/3508A/4508A/5008A
DISASSEMBLY AND REPLACEMENT
© 2015 TOSHIBA TEC CORPORATION All rights reserved
4 - 20
Fig. 4-52
Fig. 4-53