Toshiba e-STUDIO2008A Service Manual page 235

4.9.2 TRU fan (M9)
(1) Remove the transfer unit.
 P. 4-114 "4.9 Transfer unit"
(2) Remove 4 screws and take off the inner duct
[1].
(3) Disconnect 1 connector [2].
(4) Peel off the double-faced tape, and then
remove the TRU fan [3].
Notes:
When installing, pass the harness [4] through
the harness guide as shown in the right
figure.
© 2015 TOSHIBA TEC CORPORATION All rights reserved
Fig. 4-314
Fig. 4-315
Fig. 4-316
e-STUDIO2008A/2508A/3008A/3508A/4508A/5008A
4 - 115
DISASSEMBLY AND REPLACEMENT
4