Toshiba e-STUDIO2008A Service Manual page 144

(5) Remove the flat cable [5] by sliding the front
side of the exposure lamp [4] toward the
direction of the arrow shown in the figure.
Remove the exposure lamp [4] from the front
side.
4.3.7 Scan motor (M1)
(1) Take off the rear top cover.
 P. 4-6 "4.1.14 Rear top cover"
(2) Remove the rear cover.
 P. 4-6 "4.1.15 Rear cover"
(3) Disconnect 1 connector.
e-STUDIO2008A/2508A/3008A/3508A/4508A/5008A
DISASSEMBLY AND REPLACEMENT
© 2015 TOSHIBA TEC CORPORATION All rights reserved
4 - 24
Fig. 4-62
Fig. 4-63