Toshiba e-STUDIO2008A Service Manual page 807

[2D69] NetWare service not available
Classification
File sharing related error
Check item
Setting
[2DC1] Power failure
Classification
File sharing related error
Check item
Setting
[2E10] USB storage system access abnormality
Classification
File sharing related error
Check item
Setting
[2E11] Insufficient memory capacity for USB storage
Classification
File sharing related error
Check item
Setting
[2E12] Message reception error in USB storage
[2E13] Message transmission error in USB storage
Classification
File sharing related error
Check item
Setting
© 2015 TOSHIBA TEC CORPORATION All rights reserved
When a user tried to perform Scan to File with NetWare
protocol even though the NetWare setting is disabled, a
message notifies the user that NetWare service is disabled.
Check if the Netware setting is enabled.
Power failure
• Check if the power cable is connected properly and it is
inserted securely.
• Check if the power voltage is unstable.
Job status is invalid.
Turn the power OFF and then back ON. Perform the job in
error again.
If the error still occurs, check that there is no job, and format
the HDD with [5] + [C] + [START].
Memory in the USB folder is not sufficient.
If there is a job in progress, perform the job in error again
after the job in progress is finished. If the error still occurs,
turn the power OFF and then back ON, and then perform the
job in error again.
Job status is invalid.
Turn the power OFF and then back ON. Perform the job in
error again.
8 - 269
Error item
Measures
Error item
Measures
Error item
Measures
Error item
Measures
Error item
Measures
e-STUDIO2008A/2508A/3008A/3508A/4508A/5008A
ERROR CODE AND TROUBLESHOOTING
8