Toshiba e-STUDIO2008A Service Manual page 441

(9) Attach the developer material cover and
tighten 2 screws.
Notes:
1. After the developer material has been
replaced, adjust the auto-toner sensor.
(See  P. 6-2 "6.2 Adjustment of Auto-
Toner Sensor".)
2. When installing the developer unit upper
cover, make sure that the side seal
comes between the developer unit upper
cover and rubber seal on the cover.
© 2015 TOSHIBA TEC CORPORATION All rights reserved
Fig.6-46
Rubber seal
Developer unit
upper cover
Fig.6-47
e-STUDIO2008A/2508A/3008A/3508A/4508A/5008A
6 - 57
Developer
material cover
Side seal
SETTING / ADJUSTMENT
6