Toshiba e-STUDIO2008A Service Manual page 900

[D] Erase HDD
In case of the ADI-HDD:
(1) Press the [START] key in the HS-74 - [Revert factory initial status HDD].
(2) Turn the power OFF.
Incase of SATA-HDD:
(1) Press the [START] key in the HS-73 - [ Erase HDD Security].
(2) Select "LOW" (Normally use this setting), "MEDIUM", "HIGH" and "SIMPLE".
(3) Turn the power OFF.
[E] Replace / Format HDD
(1) Confirm that the power is turned OFF.
(2) Replace the HDD.
(Refer to  P. 9-4 "9.1.3 Hard disk (HDD)".)
(3) Create the partitions on the HDD.
1.Press the [START] key in the HS-73 - [Format HDD].
2.When "Operation Complete" is displayed on the LCD, creating of the partitions is completed.
(4) Turn the power OFF.
(5) Format the service tech password.
1. Press the [START] key in the HS-73 - [Clear Service Tech Password].
2. When "Reset Complete" is displayed on the LCD, formatting of the service tech password is
completed.
(6) Turn the power OFF.
(7) Update the system software using the USB device.
See "11.2Firmware Updating with USB Device" for details.
(8) Turn the power OFF.
When the Fax Board (GD-1370) is installed, perform [CUSTOM INITIALIZE]  [INIT MEMORY]
(9)
and [CLEAR DATA] in the FS-11 FAX CLEAR MODE. Then turn the power OFF.
(10) Perform 08-9930 to check the version of the system software.
Confirm the version displayed on the LCD, and then press the [OK] button.
(11) Initialization of NIC information (08-9083).
(12) Turn the power OFF.
e-STUDIO2008A/2508A/3008A/3508A/4508A/5008A
REPLACEMENT OF PC BOARDS/HDD
© 2015 TOSHIBA TEC CORPORATION All rights reserved
9 - 16