Toshiba e-STUDIO2008A Service Manual page 319

5. SELF-DIAGNOSTIC MODE
5.1 Overview
This equipment consists of two servicing menus whose start-up method differs. Setting and adjustment
can be performed by entering into a mode such as [05 ADJUSTMENT MODE] or [49 Firmware update
mode] from each menu.
• FS Menu
Mode
03 TEST MODE
04 TEST PRINT MODE
05 ADJUSTMENT MODE
08 SETTING MODE
20 PM SUPPORT MODE
21 EPU REPLACE MODE
30 LIST PRINT MODE
31 CHART PRINT MODE
FAX 11 FAX CLEAR MODE
12 FAX LIST PRINT MODE
13 FAX FUNCTION MODE
19 RAM EDIT MODE
• HS Menu
Mode
01 Control panel check mode
49 Firmware update mode
59 SRAM data cloning mode
73 Assist mode
74 HDD assist mode
75 File system recovery mode
76 SRAM clear mode
* Only the modes which are available for this equipment are displayed on each menu.
© 2015 TOSHIBA TEC CORPORATION All rights reserved
Contents
Checks the status of input/output signals.
Outputs the test patterns.
Adjusts various items.
Sets various items.
Clears each counter.
When replacing EPU, this mode is available for the
installation of the EPU whose initial detection is possible.
Prints various lists or outputs them in a CSV format.
Prints the charts.
Sets the fax board.
Outputs the contents set for the fax functions.
Sets the fax functions.
This is the mode for the special settings. (This is not used
generally.)
Contents
Checks various contents regarding the LCD, LED, hard
keys and digital keys on the control panel.
Performs firmware update with a USB storage device.
Backs up the SRAM data to a USB storage device.
Clears error flags or SRAM, or safely deletes data in the
HDD or SRAM to support the replacement of the SYS
board, SRAM or HDD.
Assists the ADI-HDD by checking the type of the mounted
HDD, reverting the HDD to a factory default or removing
keys.
Checks, recovers or initializes the file system (HDD).
Recovers the equipment from particular errors such as
F800 or F900.
e-STUDIO2008A/2508A/3008A/3508A/4508A/5008A
5 - 1
SELF-DIAGNOSTIC MODE
5