Toshiba e-STUDIO2008A Service Manual page 323

(3) Press [CLASSIC] on the upper right of the menu to display the adjustment mode menu.
(4) By using the digital keys displayed on the screen, enter [1], [2], [3], [4] and then press the
[START] button. Enter the sub codes [5] and [6] and then press the [START] button.
(5) Carry out the adjustment by following the instructions displayed on the screen or press the
[START] button.
[03 TEST MODE]:
The key-pressing procedure for the modes, which are set by the combination of the [F1], [F2] and [F3]
keys, are described as below.
[F1: ON]: Only F1 is turned ON.
[F1, 2: ON]: F1 and F2 are turned ON.
* The number of the [F] key, which is turned ON, is depicted by dividing with "," (commas) as above.
[F1, 2, 3: ON]: All of the [F] keys are turned ON.
[F: OFF]: All of the [F] keys are turned OFF.
Example:
[FS-03-F:OFF-9-A]: Turn OFF all of the [F] keys in the FS-03 mode, select [9] and then [A].
[FS-03-F1:ON-9-A]: Turn ON the [F1] key in the FS-03 mode, select [9] and then [A].
[FAX]:
In case of [FS-11], [FS-12] or [FS-13] is given in the explanations, select [FAX] in the [FS Menu] and
then press [NEXT] to choose each mode.
© 2015 TOSHIBA TEC CORPORATION All rights reserved
Fig.5-4
e-STUDIO2008A/2508A/3008A/3508A/4508A/5008A
5 - 5
SELF-DIAGNOSTIC MODE
5