Toshiba e-STUDIO2008A Service Manual page 608

8.3.2 Paper exit jam
[E010] Leading edge of paper not reaching the exit sensor
[E020] Trailing edge of paper not passing the exit sensor
Classification
Paper exit jam
Proce
Check item
dure
1 Open the Automatic
duplexing unit. Is there
any paper on the transport
path?
Is the exit sensor working?
2
(Perform the input check
in the test mode: 03-
[FAX]ON/[9]/[B])
Is the registration roller
3
clutch working?
(Perform the output check
in the test mode: 03-108/
158)
4 Registration roller
Parts to be replaced
Exit sensor
LGC board
Registration roller clutch
Registration roller
e-STUDIO2008A/2508A/3008A/3508A/4508A/5008A
ERROR CODE AND TROUBLESHOOTING
トラブルシューティングの内容がEX-Loire2のため、別途修正します。
Error content
Jam not reaching the exit sensor
Stop jam at the exit sensor
Result
Yes Remove the paper.
No
Yes
No • Check if the connector of the exit sensor is
disconnected.
• Check if the connector CN309 on the LGC
board is disconnected.
• Check if the connector pins are
disconnected and the harnesses are open
circuited.
• Check if the conductor pattern on the LGC
board is short circuited or open circuited.
• Replace the exit sensor
• Replace the LGC board
Yes
No • Check if the connector of the registration
roller clutch is disconnected.
• Check if the connector CN315 on the LGC
board is disconnected.
• Check if the connector pins are
disconnected and the harnesses are open
circuited.
• Check if the conductor pattern on the LGC
board is short circuited or open circuited.
• Replace the registration roller clutch.
• Replace the LGC board.
• Check the registration roller. Replace it if it
is worn out.
© 2015 TOSHIBA TEC CORPORATION All rights reserved
8 - 70
Measure
Remark
Next
Step
2
3
4