Toshiba e-STUDIO2008A Service Manual page 119

3.17.5 Fuse
When the power supply secondary fuse is blown out, confirm that there is no abnormality with each part
using the following table.
Voltage Board/Unit
+24VD1 LGC
Main motor
SYS
Key copy counter / Coin controller
Bridge unit / Job separator / Offset tray
PFP/LCF
+24VD3 RADF
+24VD4 Finisher
© 2015 TOSHIBA TEC CORPORATION All rights reserved
Part
Process unit fan
Toner motor
Polygonal motor
Upper Tray-up motor
Lower Tray-up motor
TRU fan
Switching regulator cooling fan
Auto-toner sensor
1st drawer feed clutch
2nd drawer feed clutch
Registration roller clutch
High speed transport clutch
Low speed transport clutch
ADU clutch
Discharge LED
Main power switch
High-voltage transformer
Bypass feed clutch
ADU motor
Exit motor
Reverse motor (35ppm/45ppm/50ppm only)
REV gate solenoid (35ppm/45ppm/50ppm only)
Scan motor
Exposure lamp (Lamp inverter board / LED board)
3 - 73
Fuse type
F201:8A (Time-lag)
F203:4A (Time-lag)
F204:5A (Time-lag)
e-STUDIO2008A/2508A/3008A/3508A/4508A/5008A
OUTLINE OF THE MACHINE
3