Toshiba e-STUDIO2008A Service Manual page 477

Notes:
Perform adjustment for the folding position first because the stapling position must be adjusted
referring to the folding line.
Phenomenon
Folding position
Specified
folding position
Stacker hook
Fig.6-98
Specified
folding position
Folding position
Stacker hook
Fig.6-99
Stapling position
Folding position
Stacker hook
Fig.6-100
Folding position
Stapling position
Stacker hook
Fig.6-101
© 2015 TOSHIBA TEC CORPORATION All rights reserved
Contents
When the folding position is deviates
from the specified one by more than
-2.0 mm
When the folding position is deviates
from the specified one by more than
2.0 mm
When the stapling position is
deviated from the specified one
more than -0.50 mm
When the stapling position is
deviated from the specified one
more than 0.50 mm
6 - 93
Adjustment
Increase the value of the folding
position adjustment in order to move
the folding stopping position (the
position of the stapling hooks) of the
stacker upward.

P. 6-96 "[ 2 ] Folding position
adjustment"
Decrease the value of the folding
position adjustment in order to move
the folding stopping position (the
position of the stapling hooks) of the
stacker downward.

P. 6-96 "[ 2 ] Folding position
adjustment"
Decrease the value of the stapling
position adjustment in order to move
the stapling stopping position (the
position of the stapling hooks) of the
stacker downward.

P. 6-94 "[ 1 ] Saddle stapling
position adjustment"
Increase the value of the stapling
position adjustment in order to move
the stapling stopping position (the
position of the stapling hooks) of the
stacker upward.

P. 6-94 "[ 1 ] Saddle stapling
position adjustment"
e-STUDIO2008A/2508A/3008A/3508A/4508A/5008A
SETTING / ADJUSTMENT
6