Toshiba e-STUDIO2008A Service Manual page 331

Procedure 6
[Digital key]
[FS] [05]
(Code)
* When the automatic adjustment ends abnormally, an error message is displayed.
* Return to standby screen by pressing the [CANCEL] or [CLEAR] button.
Procedure 7
[Digital key]
[FS]
[05] [START]
(Code)
* When the automatic adjustment ends abnormally, an error message is displayed.
* Return to standby screen by pressing the [CANCEL] or [CLEAR] button.
Procedure 10
[Digital key]
[FS] [05]
(Code)
Procedure 12
[Digital key]
[FS]
[05]
(Code)
Procedure 17
[CANCEL] or [CLEAR]
[Digital key]
[START]
[FS]
[05]
(Code)
* The automatic adjustment starts when 2 seconds have passed after the [START] button is pressed.
Notes:
The temperature control of the heat roller at the 05 adjustment mode is different from that at the
normal state. Therefore, a problem may occur in the fusing ability during the test copy at the 05
adjustment mode. In that case, turn the power ON normally and leave the equipment for approx.
3 minutes, and then restart the adjustment mode.
Refer to the "Self-diagnostic code list" (separate document) for the codes available in the [05
ADJUSTMENT MODE].
© 2015 TOSHIBA TEC CORPORATION All rights reserved
Automatic
[START]
adjustment
*[CANCEL] or [CLEAR]
[CANCEL]
[Digital key]
[START]
(Sub code)
[CLEAR]
(Corrects value)
*[CANCEL] or [CLEAR]
[Digital key]
[START]
(Sub code)
[OK]
(Value unchangeable)
[START] [Digital key]
(Key in a value)
[CLEAR]
(Corrects value)
[CANCEL]
[UP]
or Automatic
(
[DOWN] adjustment
(Adjust a value)
5 - 13
[ Test cop ]
[ START ]
[OK]
Automatic
Stores value
adjustment
in RAM
[ Test copy ]
[ START ]
Value
[START]
displayed
[ START ] (Ringing)
[ CLEAR ]
[OK]
[UP]
or
or
)
[INTERRUPT]
[DOWN]
(Adjust a value) Stores value
in RAM
e-STUDIO2008A/2508A/3008A/3508A/4508A/5008A
[POWER]OFF/ON
(Exit)
[POWER]
OFF/ON
(Exit)
[POWER]
[START]
OFF/ON
(Exit)
[POWER]
[OK]
OFF/ON
(Stores value
(Exit)
in RAM)
[FAX]
[POWER]
OFF/ON
[STAR T]
(Exit)
(Test copy)
SELF-DIAGNOSTIC MODE
5