Toshiba e-STUDIO2008A Service Manual page 890

Notes:
• When removing the flat cables [4], pull out
the flat cables [4] while pushing the
actuators [3].
• When connecting the flat cables [4] to the
actuators [3], connect them until a click
sound is heard.
Notes:
• When installing the flat cables [4], do not
push them in strongly.
• When installing the flat cables [4], be
careful not to insert them at an angle.
• Do not apply pressure to or damage the
edge of the flat cables [5].
(4) Remove 4 screws and take off the LGC
board [1] by sliding it toward the right side.
Notes:
The LGC board to be installed differs
depending on the models. Due to this, before
replacing, be sure to check the color of the
identification label on the LGC board to
install the corresponding one in the
equipment.
• 20ppm: White
• 25ppm: Pink
• 30ppm: Blue
• 35ppm: Yellow
• 45ppm: Green
• 50ppm: Red
e-STUDIO2008A/2508A/3008A/3508A/4508A/5008A
REPLACEMENT OF PC BOARDS/HDD
Fig. 9-15
Fig. 9-16
Fig. 9-17
© 2015 TOSHIBA TEC CORPORATION All rights reserved
9 - 6